REMOVE THESE
PARTS FOR:
8018: steps 1-4
SHOCK/ANTENNA MOUNT
Remove the shock cap bushing from
the #8184 shock antenna mount.
Install the mount using two #6938
aluminum screws.
5407, qty 2
red O-ring
6464, qty 1
shock piston #1
5422, qty 1
30 wt
silicone oil
1:1
1:1
TOOLS USED
step 1
LEFT SIDE
6464
TRIM SHOCK PISTON
Burrs interfere with smooth shock action
within the shock body. To remove from tree
without creating burrs, twist up, not down.
Remove one #1 shock piston.
Remove remaining burrs carefully with
hobby knife.
burr
wrong
right
step 2
VC FOAM AND PISTON
Soak the #8456 VC foam
with #5422 shock oil and
install it onto the #8456
VC bobbin.
step 3
6469, qty 1
large O-ring
6299, qty 2
E-clip
1:1
1:1
6938, qty 2
4-40 x 1/2
blue aluminum
1:1
8458, qty 1
macro shock
body
6460, qty 1
shock shaft
8184, qty 1
shock/antenna
mount
remove this part,
then put aside
for later assembly
1:1
7230, qty 1
ball cup
1/16"
6938
6938
2
5422
OIL
Install the #6469 O-ring over the
threads of the #8458 shock body.
Install a #6299 E-clip on either side of
a #6464 (#1) piston.
Slide the assembled VC foam/bobbin
over the #6460 shaft and then two
#5407 red O-rings. Place a couple of
drops of oil on the O-rings.
Insert the assembly into the shock
body and pull the shaft through firmly
to seat the VC bobbin at the base of
the shock bore.
Screw the #7230 ball cup onto the end
of the shock shaft while holding the
shaft with needlenose pliers
next to
threads.
step 4
5422
OIL
6299
6299
6469
8458
5407
7230
8
8184
8184
8456
foam
8456
bobbin
6460
6464 (#1)
8456, qty 1
VC foam
1:1
8456, qty 1
VC bobbin
Use a piece of paper or
smooth part of jaws to
prevent damaging shaft.
8456