Associated Electrics 90035, Manual

17

:: 

:: Bag 9 - Step 6

Bag 9 - Step 6

:: 

:: Bag 9 - Step 5

Bag 9 - Step 5

:: 

:: Bag 9 - Step 4

Bag 9 - Step 4

Front Shock: 30wt

#5422

Rear Shock: 30wt

#5422

Shock fluid

Shock fluid

Steps 9-10

Step 8

Steps 6-7

Steps 4-5

Steps 2-3

Shock Bleeding Steps:

1. 

Before assembly, get each bleed 

screw and thread it 1-2 turns into 

the shock cap, then remove the 

screw.  This will make it easier when 

you are bleeding your shocks.

2. 

Pull shock shaft down.

3. 

Fill shock body 3/4 full with silicone 

shock fluid.

4. 

Slowly move the shock shaft up and 

down to remove air from under the 

piston.

5. 

Wait for bubbles to come to surface.

6. 

Fill shock body to top with silicone 

shock fluid.

7. 

Place a drop of oil in the cap and on 

cap threads.

8. 

Install cap (without bleed screw) and 

tighten completely.

9. 

Slowly compress shaft all the way to 

bleed excess silicone shock fluid out 

the hole in the cap (use rag around 

shock to catch excess fluid).

10.  Install M2x4mm button head 

screw until snug while shaft is fully             

compressed.

31510

M2 x 4mm 

BHCS

91926

13mm 

Shock Cap

Stroke

Front: 21mm

Rear: 27.5mm

Stroke

91928

13mm 

Threaded 

Collar 

91996

13mm 

Threaded 

Collar 

O-ring

x4

x4

x4

x4

Build x2 front shocks

Build x4

Build x2 rear shocks

91941

13mm Front 

Spring, Gray 

(3.40lb)

91948

13mm Rear 

Spring, White 

(1.90lb)

Racers Tip:

Use your finger to rub 

shock fluid on the O-ring 

for smoother 

adjustment!

91926

13mm Shock 

Spring Cup

“Rear - 0mm”

91926

13mm Shock 

Spring Cup

“Front - 5mm”

Front: 

4.50mm

Rear: 

6.50mm

#91926 13mm Shock Spring Cups

0mm

5mm

9mm