Step 2
15
Step 1
s t e p 1
1:1
6465, qty 2
shock piston #1
B A G L
REMOVE THESE
PARTS FOR:
Steps 1-2
REMOVE SHOCK PARTS
Remove the #6440 shock
parts from the molding tree
carefully so no part of the
molding runner remains. It is
safer to remove a tiny
amount of the shock part
than to risk the chance of a
burr remaining on the part.
Short blade scissors or a
hobby knife will work.
1:1
5407, qty 8
red O-ring
TEAM/FT 6435, qty 2
1.32 rear shock body
1:1
6465, qty 2
shock piston #2
6440, qty 4
split locking washer
1:1
6440, qty 8
small spacer
1:1
6440, qty 4
large spacer
6429, qty 1
shock assembly tool
5422, qty 1
30 wt oil
TEAM/FT 6436, qty 2
1.02 front shock body
6465
TRIM SHOCK PISTONS
Burrs interfere with smooth
shock action within the shock
body. To remove from tree
without creating burrs, twist
up, not down. Remove two
each of #1 and #2.
Remove remaining burrs
carefully with hobby knife.
burr
wrong
right
2
s t e p 2
Install the shock parts onto the #6429 shock tool as shown.
One shock clip (split locking washer), one thin spacer, one
red O-ring, one thick spacer, one red O-ring, and one thin
spacer.
Remove the #5422 oil and add 3-4 drops to the inside of
the shock body and to the seal parts.
Insert the tool and the seal parts into the shock body all
the way. Push easily until the parts snap into place.
Check the tool height in fig. 2-4. The left shock shows just
before snapping into place, the right shows after.
Assemble the remaining shocks the same way.
If your shocks do not snap together easily, check the
internal parts for burrs again.
DISMANTLING SHOCK
PARTS
Here is how to dismantle the
shocks when it's rebuild time.
Put the shock assembly tootip
into thebottom the shock until
it rests against the small
washer as shown, then push
to unclip the shock clip (split
locking washer).
5428
O IL
6429
5407
O IL
5428
fig. 2-4
BEFORE
SNAP
AFTER
SNAP
6429
6440
small
washer
shock
clip
shock
tooltip
shock
interior
5
s t e p 3
REAR BODY MOUNTS
Attach the #7323 small round posts to the #7323 rear body
mounts with two #6285 (6284*) screws.
Push the pegs of the rear body mounts into the lower holes
from the back of the tower.
Screw the #6924 (6860*) screws into the middle hole from
the front of the tower to secure them.
7323
6924,
6860*
7323
6285, 6284*
7323
7323
6924, 6860*
RTR/TEAM BUILT 6424B, qty 2
blue 1.32 rear shock body
RTR/TEAM BUILT 6425B, qty 2
blue 1.02 front shock body
