Associated Electrics RC10GT, Instruction Manual

R T R

T E A M / F T

6951, qty 2 
4-40 x 1/8" set screw

1:1

6951

1:1

7874, 7873*, qty 2
4-40 x 7/16 screw

1:1

6932, 6933*, qty 2
4-40 x 5/16 screw

7315, qty 2
blue nose brace tube

B A G   B

REMOVE THESE 
PARTS FOR:
Step 6

T O O L S   U S E D

3/32"

6

s t e p   6

NOSE BRACE TUBES
The #7315 nose tube has threaded holes and non-threaded holes 
through its sides. Slide the #7315 front nose tube's unthreaded hole 
end through the front shock tower's oval shaped holes.
Install one #7874 (7873*) screw through the bulkhead and through 
the nose tube, but do not tighten it down all the way.
Line up the back hole in the nose tube to the nose tube mount. Install 
one #6932 screw from the outside as shown. Now tighten down the 
front screws.

7315

7874, 7873*

6932

6932

threaded hole

non threaded hole

7874, 7873*

6932

1:1

6273, qty 4
long ball end

1:1

6936, qty 4
#4 washer

6221, qty 2
steering block arm
(left arm shown)

B A G   C

REMOVE THESE 
PARTS FOR:
Steps 1-2

T O O L S   U S E D

1:1

7260, qty 4
small plain nut

6220, 6220B*, qty 2
front axle

6210, qty 2
steering (caster) block
(left block shown)

1:1

6223, qty 2
kingpin

1:1

6299, qty 8
E-clip

1:1

6272, qty 4
ball end dust cover

1:1

6227, qty 2
front outer hinge pin

s t e p   1

STEERING (CASTER) BLOCK ASSEMBLY
Attach the #6273 ball end to the #6221 steering block with two 
#6936 washers. Thread a #7260 plain nut on the opposite side.

CASTER BLOCKS TO ARMS
Attach one caster block assembly to the 
#7206 a-arm with a #6227 hinge pin.
Add A #6299 E-clip to both sides.
Now assemble the other side.

s t e p   2

Push the #6220 (6220B*) axle 
into the #6221 steering block, 
lining up the holes.
Now locate the left #6210 caster 
block and align the holes of the 
steering block assembly and 
caster block. 
Add a #6299 E-clip to one end 
of the #6223 kingpin and insert 
it through both blocks. 
Add a #6299 E-clip to the other 
side of the #6223 kingpin.
Attach the #6273 ball end to the 
caster block as shown. Thread 
one #7260 plain nut on the 
opposite side.
Add #6272 foam dust covers to 
the ball ends. Tighten the #6951 
set screw against the kingpin.
Now do the right block.

6223

6221
(left shown)

6936

7260

6220,
6220B*

6210
(left shown)

6299

6273

6936

6299

6273

6272

6272

7206

6227

6299

6299

7874, 7873*

7260

ASSEMBLED