To reduce the risk of injury or death:
1.
READ AND FOLLOW ALL SAFETY, INSTALLATION
AND OPERATION INSTRUCTIONS.
If you have any questions or do not understand any instruction,
contact us directly.
Phone Number: (800) 843-5625 ex.711
Email:
tech@SureLock4Homes.com
2. If you are uncomfortable performing any of the following tasks, have
SureLock installed by a professional.
3. All wiring is to be employed as required by local codes.
4. Disconnect garage door opener from source of power before installing
SureLock, and
DO NOT
reconnect opener to source of power until
instructed to do so.
5. Install manual release signage labels supplied with SureLock, as
described at the end of instructions.
Drill Hole Template
SureLock
Control Module
SureLock
Sensor
SureLock
4 Pin Harness (6’)
Backup Battery Harness (2’)
Manual Release Signage Labels (x2)
Staples (x7)
Cover Plate Replacement Screw
1" Hole Saw
Wire Tie
Drill, ¼" Drill Bit, Small Round File, Wire Cutters, Hammer, 7/16" Wrench
Phillips & Flat-Blade Screwdrivers
And just in case you need us, our contact information is as follows:
Phone Number: (800) 843-5625 ex.711
Email:
tech@SureLock4Homes.com
WARNING
IMPORTANT INSTALLATION INSTRUCTIONS
A: SureLock
B: Red Manual Release Lever
C: Lock Bar
D: Lock Bar Hinge
E: SureLock Wire (30')
F: 1/4" Bolts (x3)
G: 1/4" Nuts (x3)
Parts Not Shown
Parts List Shown
Tools Required For Installation
Email: tech@ProductConceptsInc.com
Email: tech@ProductConceptsInc.com
