AST SureLock SLGDL-7, Operation And Installation Manual

  18. 

Optional: Backup Battery Harness Installation.

        If your Garage Door Opener is equipped with a back-up battery      
        you will need to use the back-up battery harness equipped with Surelock.
        
        

Opener Equipped with 12VDC Back-up Battery

        1) Locate the back-up battery in the garage door opener and disconnect 
            the two wires connecting the battery to the opener. 
        2)  Next you will plug the Surelock Back-up Battery Harness Piggy-Back 
            terminals onto the garage door opener's back-up battery. 
            The Piggy-Back Connectors must be plugged onto their mating battery 
            terminals (size & color).
        3) Plug the previously disconnected Garage Door Opener's back-up 
            battery wires onto the mating Piggy-Back terminals (size & color). 
        4) Safely route the harness wires from the garage door opener's battery 
            mounting location to the Surelock sensor mounted atop the garage 
            door opener. Make sure that the wires are never pinched, cut or 
            routed near moving objects.
        5) Plug the Surelock back-up battery harness into the Surelock sensor's 
            mating 2-pin connector.

         Opener Equipped with Backup Batter, But Not 12 VDC

        1) Purchase a 12 Volt DC Non-Spillable battery (4ah minimum).
        2) Securely mount the battery at the garage door opener.
        3) Plug the SureLock Back-up Battery Harness's piggy-back connectors 
            onto the backup battery previously purchased and securely mounted.  
            The piggy-back connectors must be plugged onto their mating backup 
            battery terminals (Color & Size).
        4) Plug the SureLock Back-up Battery Harness into the SureLock 
            Sensor's mating 2-Pin connector.

MANDATORY GARAGE DOOR OPENER ADJUSTMENT

 DO NOT proceed without performing this mandatory adjustment. 

           Failure to complete this adjustment may cause damage to the 
                        garage door and/or garage door opener.

  1. Confirm 

SureLock's

 red manual release lever is in the unlocked position.

      (away from door track)

  2. Locate the garage door opener instruction manual and up-force sensor 
      adjuster.

  3. Following the garage door opener instructions, adjust the garage door 
      opener's up-force sensor to a (minimal) setting that shuts-off the garage 
      door opener in the unlikely event a jam occurs, to avoid damaging the 
      garage door and/or garage door opener.

WARNING

Do Not Operate The Garage Door Opener 

Until Instructed To Do So.