Aston Technologies Inc.
www.astontechusa.com
- 13 -
Fig.1
2. Continuously press the keys
▽
,
△
and F
of distance dimension A, shown in Fig.2, if
the value displayed is not correct, press
the keys
△
and
▽
of width dimension L to
adjust.
Fig.2 Standard Memory
Correcting the degree of accuracy of value
3. Press the key
△
of distance dimension A,
as Fig.3 shown, which is that adjusting
static balancing parameters. When offset
data are too many, adjust to shown in
Fig.3.
Fig.3 Standard Memory
Correcting value 100g of inner of static balancing
4. Then press the key
△
, as Fig.4 shown,
if the value displayed is not correct,
press the keys
△
and
▽
of width
dimension L and adjust.
Fig.4 Standard Memory
Correcting the error of degree
5. Return by pressing the key
△
of
distance dimension A.
6. After correcting, self-calibrate again,
see 5.1, or else correct ineffectively.
5.3 Trouble shooting
Troubles
Reasons
Solutions
Do not display after starting.
1. Check outer circuit.
2. Check whether the
switch is damaged.
3. Main board and
power panel are
damaged.
1. Check it with multi-meter.
2. Replace it.
3. Replace it.
Display after starting but do
not work and buzz, display
Err1.
Capacitor of motor did
not work.
Replace
a
20UF/400V
capacitor.
Summary of Contents for ADP-2000L
