Aston
®
Tire Changer ATC-5800 User’s Manual
|
36
www.astontechusa.com
is lower, you need to unscrew the oil F, and then as figure 15-a., control oil mist level,
HG ISO and viscosity of VG32 ISO type oil mist is recommended. (like
：
ESSO Febis
K32
，
MOBIL Acauline 1405
，
KLUBER32). when stepping the pedal 3 to 4 times, check
whether there are oil drops into the oil cup F, if not, adjust screw D.
◇
As shown in figure 15-b, 20 days after the first use of the machine, re-tighten the screw
A and B that is in the clamps.
◇
As shown in figure 15-c, machine horsepower is not enough, check the triangle belt of
the motor by the following steps: (before any operation, to cut off the power) first,
Unscrew the 4 screws on the side of the box, remove the left side protective plate of the
tire changer, second, use special adjustment screw X (Figure 15-c) that is in the motor
support base to adjust the triangle belt.
◇
As shown in figure 15-d, If the (I) lock is not good or cannot be stopped at the top of the
2mm, it is necessary to adjust the nut on the operating arm.
◇
As shown in figure 15-e, when cleaning or replacing silencer which controls the opening
or closure of the clamps(G), follow the following steps: first, unscrew the 4 screws on
the side of the box, remove the left side protective plate on the tire changer. Second, in
the pedal (V1, V2) system which controls the opening or closure of the clamps(G),
unscrew silencer. Clean with compressed air nozzle, if damaged, replace with the same
parts.
