Top Rail Assembly To Shower
The set screw
locations in rail end
a re not centered.
Assemble per
drawing.
9
14mm
,
Omm
0
0
8mm
12mm
The set screw
cations in rail en
are not centered
Assemble per
drawing.
1. Loosen set screws in both rail ends (5) and remove from top rail (2). See figure 1- 1.
Next remove wall mounts (6) from both rail ends (6). Position wall mounts (7) onto
marked location on shower wall and mark pilot hole drilling location. See figure 1-2.
NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final size.
1 1
Summary of Contents for Langham SDR978
Page 18: ...Installing the door seals Install the door seals according to the drawing 1 7 ...
Page 25: ...Notes 24 ...
Page 26: ...Notes 25 ...