NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final size.
4. Using the appropriate drill bit for your tray surface drill the hole locations with a
1 /8" diameter drill bit. Repeat for the other side. See figure 4.
5. Add a small amount of silicone sealant to bottom of threshold bar assembly
place into position. See figure 5.
6. Using the hardware from screw pack 3 install the threshold bar assembly.
Install the decorative screw plug covers into threshold end caps (12). See figure
6.
16
Summary of Contents for Langham SDR978
Page 18: ...Installing the door seals Install the door seals according to the drawing 1 7 ...
Page 25: ...Notes 24 ...
Page 26: ...Notes 25 ...