Shower Door Installation
1. Measure the width of the shower opening at the top between the 2 walls. Note
this is dimension "X".
The following equation is used to determine the length to be cut from the rail in
order to fit the shower opening.
Y = X - 1/2"
2. Measure distance "Y" from the end of the Top Rail (2) with mounting holes and
mark the rail.
3. Using a Hack saw or Jig saw cut the Top Rail (2) at the mark. Carefully
remove any burrs or sharp edges remaining on Top Rail (2) after the cutting.
Note: Don not cut the end of top rail with two (2) holes. Only cut the end of top
rail opposite the two (2) holes.
8
Summary of Contents for Langham SDR978
Page 18: ...Installing the door seals Install the door seals according to the drawing 1 7 ...
Page 25: ...Notes 24 ...
Page 26: ...Notes 25 ...