Revision 1.1
4.
Connect the CB110 3-way Power & Ignition Cable
a.
Plug the CB110 cable into the small white socket on the front panel of the AT110
(note: the key on the CB110 plug matches the notch at the top of the socket)
b.
Connect the power and ignition (if required) as outlined below:
7 - 32V
GND
IGNITION
CB110 cable
red
black
white
c.
Connect the IGNITION wire to an ignition switched 12/24V signal (i.e. something that
only goes live when the vehicle ignition is ON). This is not necessary when using
IGNM=3, in this mode engine running is detected from external voltage
5.
Fit the SIM:
a.
Slide the SIM into the AT110 slot with the notched corner to the left-hand side, as
below:
b.
Ensure the SIM is pushed in all the way
c.
Note that the AT110 will now power up
d.
Both LEDs will illuminate
e.
You should see text on your TeraTerm screen
f.
To remove the SIM, push it inwards, and it will spring out
6.
Configure Settings
a.
Once the device is running and you can see output text scrolling in TeraTerm, you are
ready to configure the device by typing or pasting commands into the TeraTerm
window (note: these commands can also be sent by SMS).
b.
Configure GSM/GPRS network operator APN settings to suit your SIM using the
following commands:
$APAD,<apn_address>
$APUN,<apn_username>
$APPW,<apn_password>
if you don
’
t know the appropriate APN settings for the network operator you are
using, please ask your SIM provider. In some cases, you may be able to find the
appropriate settings on this webpage:
http://www.taniwha.org.uk/gprs.html
