5.
Move to the outer edge of the canopy and take hold of one of the double-layered
corners with eyelets. Align this corner over one of the struts of the frame, ensuring the
seam rising from that corner runs upwards along the strut all the way to the hub (and
is not twisted across multiple struts). You may need to jostle the canopy slightly to
achieve this.
6.
Take one of the screws provided and a screwdriver, pull down on the double edged
corner, and use the screw to fix the eyelet corner to the plastic fitting at the end of the
strut as shown below.
7.
Move around the umbrella one strut at a time repeating Step 6 for all remaining
struts/ corners until all the canopy corners are fixed to the frame.
8.
Now that the canopy is fully attached to the frame, thread the round canopy cover cap
till fully secure by rotating clockwise until tight as shown below.
