3
For a line in which there are projectors, the sections are lengths are:
A modulator and projectors can be in the same line.
4. ASSEMBLY:
The floodlamp should be placed on the wall of the pool at approximately 700 mm from the water surface (Fig. 1).
The method of fastening the crosshead mount to the pool wall varies depending on whether it is a floodlamp for concrete pools or
prefabricated pools.
Concrete pool (MODEL 41127)
Place the crosshead mount of the flat floodlamp in the designated place. Mark the holes. Drill with a 6
∅
bit and insert the 4
fastening blocks.
Position the crosshead mounted so that the word “TOP” is located on the upper part.
Use four 4.8 x 25 screws to secure the crosshead mount to the wall (Fig 1).
Place the conduit body in the upper left quadrant of the crosshead mount, in accordance with the measurements shown in Fig. 2.
Prefabricated pool (MODEL 41128)
Place the crosshead mount of the flat floodlamp in the designated place. Mark the holes. Drill with a 6
∅
bit.
Position the crosshead mounted so that the word “TOP” is located on the upper part.
Use four M-6 x 35 screws with four O-rings to secure the crosshead mount to the inner wall of the swimming pool, place 4 butt joints
between the mount and the liner. On the outer side of the swimming pool, insert 4 washers and 4 nuts (Fig. 1).
Place the conduit body in the upper left quadrant of the crosshead mount, in accordance with the measurements shown in Fig. 2.
Use the butt point and the conduit nut to secure on the outer side of the swimming pool.
The floodlamp is supplied with 2,5 m of cable. It should be inserted through the conduit body (Fig. 4), leaving approximately 1.50 m
of cable in order to be able to remove the floodlamp to the border of the swimming pool if handling or change is required (Fig. 3).
Wind the cable in counter-clockwise direction under the screen fastening clamps.
Firmly secure the gland seal nut (Fig. 6).
In order to secure the floodlamp to the crosshead mount, ensure that the word “TOP” is located on the upper part. First, insert the
lower clamp of the screen in the crosshead mount.
Then, press on the upper part until the floodlamp is firmly inserted in the crosshead mount.
5. MAINTENANCE:
This projector does not require any type of maintenance work. If you notice that the projector is not working properly, please contact
our customer attention service.
5 projectors in the line
L.Projector (m)
Section
10 - 18
10mm² Cu
7 - 10
6mm² Cu
4 - 7
4mm² Cu
0 - 4
2,5mm² Cu
10 projectors in the line
L.Projector (m)
Section
0 - 9
10mm² Cu
2 projectors in the line
L.Projector (m)
Section
25 – 45
10mm² Cu
18 - 25
6mm² Cu
10 - 18
4mm² Cu
7 - 10
2,5mm² Cu
0 - 7
1,5mm² Cu
1 projector in the line
L.Projector (m)
Section
55 – 90
10mm² Cu
35 – 55
6mm² Cu
20 – 35
4mm² Cu
14 – 20
2,5mm² Cu
0 – 14
1,5mm² Cu
