Astralpool 33034, Installation And Maintenance Manual

2 

ENGLISH 

IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented 
for installation and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation 
and start-up. 
Keep this manual for future reference. 

To achieve optimum performance of the Underwater Swivel Projector follow the instructions provided below: 

1.   VERIFY THE CONTENTS OF THE PACKING: 

 
The following accessories are included inside the box: 
 
Concrete pool floodlamp: 

Housing body 
Floodlamp unit 

 
Prefabricated pool floodlamp: 

Housing body 

Watertight joint 

Clamp  

Floodlamp 

unit 

Bag of screws:    

16 DIN 7982 A2 5,5x25 screws 
16 DIN 966 A2 M-6x24 screws (1) 

 
Panelled pool floodlamp: 

Housing body 

Watertight joint 

Clamp  

Floodlamp 

unit 

Bag of screws:    

16 DIN 7982 A2 5,5x25 screws 
16 DIN 966 A2 M-6x24 screws (1) 
8 DIN 7982 A2 M-4,8x25 screws 

 
(1) 

Only for models with Housing body with inserts 

2. GENERAL CHARACTERISTICS: 

 
This floodlamp has been designed to be used fully submerged underwater in fresh water swimming pools. It is a Class 
III electric apparatus with very low safety voltage (12V with alternating current). 
The floodlamp compiles with IPX8 degree of protection (resistance to penetration of dust, solid bodies and humidity) 
at a nominal immersion depth of 2 m. 
This floodlamp compiles with international safety standards for lights, especially the EN 60598-2-18 standard. 
LIGHTS PART 2: SPECIFIC REQUIREMENTS SECTION 18 LIGHTS FOR SWIMMING POOLS AND SIMILAR 
APPLICATIONS. 
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric 
components which have been inserted or handied at locations other than its own premises. 
 

3. INSTALLATION: 

•

Never install the projector with the lamp facing upwards. 

•

In order to clearly light a pool it is recommended lo install a 300W floodlamp every 25 or 35 m² of water surface. 
In swimming pools which are especially deep, a 300 W floodlamp is required for every 30 or 40 m³ of water 
volume. 

•

In order to prevent glare, the floodlamps should be installed so that they face away from the residence or usual 
view of the swimming pool. 

•

In the event that lighting is used in training or competition pools, the floodlamps should be installed on the sides 
to prevent glare on the swimmers. 

•

To avoid the need to empty the pool to change the lamp, we recommend that the floodlamp be installed in areas 
which are accessible from the upper edge of the pool. 

The floodlamp should be placed on the wall of the pool at approximately 400-700 mm from the water surface (Fig. 
1). 

Concrete swimming pool with glass mosaic tile’s: 

Fig. 2