5
QB800 robotic cleaner
Owner’s Manual
4
QB800 robotic cleaner
Owner’s Manual
SAVE THESE INSTRUCTIONS
CAUTION
Failure to comply with the following warnings could cause damage to pool equipment or personal injury.
• The robotic cleaner must be installed and operated as specified.
• This product is intended for use with permanently-installed pools. Do not use with storable pools. A permanently-
installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage.
A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its
original integrity.
• Clean the filter canister in the cleaner after each use.
• Do not use the product in your pool if the water temperature is above 35˚ C (95˚ F) or below 13˚ C (55˚ F).
USE OF THE ROBOTIC CLEANER IN A VINYL LINER POOL
Certain vinyl liner patterns are particularly susceptible to rapid surface wear of pattern removal caused by objects
coming into contact with the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and
automatic pool cleaners. Some vinyl liner patterns can be seriously scratched or abraded simply by rubbing the surface
with a pool brush. Ink from the pattern can also rub off during the installation process or when it comes into contact
with objects in the pool. AstralPool Group Australia Pty Ltd is not responsible for, and the Limited Warranty does not
cover, pattern removal, abrasion or markings on vinyl liners.
Section 2. Cleaner Specifications
The general specifications for the cleaner are as
follows:
Control box
supply voltage
220-240 VAC, 50 Hz; short
circuit-proof safety isolating
type
Supply voltage
30 V DC
Installed load
150 W max
Cable length
15M
Cleaner size
(WxDxH)
43 x 48 x 27 cm
Weight of Cleaner
9.5 kg
Packed weight
19 kg
Filtration
All-purpose filter canister
Cycle lengths
Variable programming.
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a
safety connection to ground. The basic requirement
for double-insulation is that no single failure can
result in dangerous voltage becoming exposed so
that it might cause an electric shock and that this is
achieved without relying on an earthed (grounded)
metal casing. This is achieved by having two (2)
layers of insulating material surrounding live parts
or by using reinforced insulation. Therefore, devices
having double-insulated construction, such as this
cleaner, do not utilize a grounded (three-prong)
cord/plug.
