17
VIRON™ QT 1000 robotic cleaner
owner’s Manual
16
VIRON™ QT 1000 robotic cleaner
owner’s Manual
To replace a worn brush:
1.
Lift the cleaner to a vertical position so that the handle
is up (Figure 26).
1
Figure 26. Place Cleaner in Upright Position
2.
Separate the edges of the brush and undo the tabs.
Remove the worn brushes.
2
Figure 27. Undo the Tabs of the Brush
3.
To install the new brush, position the new brush on
the roller with the cleaning blades facing away from
the roller.
3
Figure 28. Install the New Brush
4.
Thread each tab into the slot provided and gently feed
it through until the heel comes out at the other side of
the slot.
4
Figure 29. Pull Tabs Through Each Slot
5.
Use a pair of scissors to cut the tabs 3/4 inch from
the heel so that they are no higher than the cleaning
blade.
6.
Repeat the procedure to install the second brush.
Figure 30. Cut Tabs