Installation
900378-00 04/2017
Innovative Hearth Products
MHD35 Series Direct-Vent Gas Fireplaces
48
Installing Gas Conversion Kits
WARNING
The gas supply shall be shut OFF prior to disconnecting the electrical power, before
proceeding with the conversion.
AVERTISSEMENT
Avant d’effecteur la conversion, coupez d’abord l’alimentation en gaz, ensuite, coupez
l’alimentation electrique.
1.
TURN OFF THE GAS SUPPLY TO THE FIREPLACE and disconnect power supply at the circuit breaker. Ensure
fi replace is cold.
2.
Open the lower control compartment door
(
Page 52
)
.
3.
Remove the barrier, front glass door/frame from the fi replace
(
Page 57
)
.
4.
Remove the logs. If necessary, remove the log grate.
NOTE:
Exercise care so as not to break the logs
(
Page 55
).
5.
Remove the sub fl oor.
6.
Remove the two (2) screws securing the burner assembly. Remove the burner assembly with the attached
venturi tube.
Millivolt Fireplaces
7.
Refer to the instructions provided with the SIT Regulator Conversion Kit, and
Figure 42
. Using a Torx T20
driver (with 1/4” shank) or slotted screwdriver, remove and discard the pressure regulator mounting screws
(two screws for electronic models, three screws for millivolt models), pressure regulator tower, the diaphragm
assembly (if applicable) and the spring. Discard all removed components.
Figure 42 - Valve Regulator Conversion (millivolt
shown)
Pressure
Regulator
Remove
These
Components
Pressure
Regulator
Remove
these
components
8.
Install the new pressure regulator assembly using the supplied screws. Tighten the screws to 25 in. lbs.
9.
Install the enclosed identifi cation label to the valve body where it can be easily seen.
10.
Remove the pilot hood assembly to access the hex pilot orifi ce
(
Figure 43, page 49
)
. Remove and replace the
pilot orifi ce with the one provided with the kit. Exercise extreme care to prevent damage to or breakage of the
igniter assembly.
11.
Remove the burner orifi ce from the manifold and replace it with the one provided in the kit
(
Figure 44, page 49
)
.
NOTE:
See
Table 5, page 10
for burner orifi ce sizes.
