1
5-21-15 TI175-95-1
ASTRO TOOL CORP.
CONNECTOR ASSEMBLY TOOLING
CYCLE CONTROLLED C-FRAME STYLE CRIMP TOOL
620175 (M22520/5-01) AND ASSOCIATED TYPES
INSTRUCTIONS FOR USE OF 620175 CRIMP TOOL
GENERAL:
The Astro Tool Corp. 620175 Hex Die Crimping
Tool is a cycle controlled, manually operated, C-
frame tool for crimping shield terminating ferrules,
RF connector fittings, and other terminations
requiring an open frame crimp tool.
There is only one set up operation required -
installing the required die set. Die sets are available
in single, double and triple hex cavities. Special
form crimps are also obtainable, consult the factory
for details.
The Tool's precision cycle control mechanism
assures a high quality, repeatable crimp. The in-line
action of the dies and toggle mechanism reduces the
compression force required to complete the crimp.
For long life and optimum performance, this tool
should be kept clean and handled with the care of
any other precision device.
OPERATION
a. Open and close the tool several times and
observe the precision cycle-control mechanism.
Note that the tool cannot be opened without
completing its cycle.
b. Identify the parts in figure #1:
1. Ratchet Handle
2. Movable Die Nest
3. Stationary Die Nest
4. Key
Movable Die
Nest
Key
Stationary
Die Nest
Ratchet
Handle
Figure #1
c. Die Installation
1.
The tool must be in the fully open position
as shown in figure #2.
2.
Locate the Stationary Die and engage the
keyway of the die with the key of the tool.
Press the die into place. See figure # 2.
Shank
Press
Key
Figure #2
3.
Locate the Movable Die and engage the
keyway of the die with the key of the tool.
Press the Die into place. See figure # 3.
