ABOT4001 REV1
BATTERY POWERED CRIMP TOOL
DATASHEET
________________________________________________________________________________________________
ABOT4001 rev1-DS
©2014 Astro Tool Corp., All Rights Reserved Page 4 of 8
REV. A
3/3/2016
Astro Tool Corp.
21615 SW Tualatin-Valley Hwy. Beaverton, OR 97003
Phone: 503-642-9853 Fax: 503-591-7766 Email: sales@astrotool.com
Identification
Figure 2
Specifications
Crimp Tool
Length=13.4” (340mm)
Width=2.9” (74mm)
Depth=4.3” (109mm)
Mass/Weight (with battery)=3.74lb (1.7kg)
Sound Level=75db (A) at 1 meter
Vibration=<2.5m/s
2
Hydraulic Oil=Shell Tellus® T-15
Crimp Capacities
Crimp Force=1.1 tons (13kN)
Avg. Crimp Time=2 seconds
Avg. Crimps per Charge=Approx. 150
Battery
Charging Voltage=18VDC
Charging Time=22 minutes
US Pat. No. 7,254,982
Operation
LED Work Light (White)
This LED automatically turns on when the trigger is pulled. It
remains on for 10 seconds after the trigger is released.
LED Indicator (Red)
This tool is equipped with a special circuit board
incorporating several important features to inform the user
about the current status of the unit. The red LED on the side
of the tool signals in the following cases:
What Happens…
Signal What it Means…
Flashing for 2
seconds
••
Battery is inserted in tool
Constant light for 20
seconds at end of
cycle
____
Battery charge is below 17V at
beginning of cycle
Tool will
not
start,
and constant light
for 20 seconds when
trigger is released
____
Battery charge is below 16V at
beginning of cycle
Tool stops, and
constant light for 20
seconds after trigger
is released
____
Battery voltage drops below 13V
during cycle
Tool stops, and
flashing light for 20
seconds after trigger
is released
••••
Motor current exceeds 20A during
cycle
Circuit has become too hot
Pressure Sensor
This tool is equipped with a pressure sensor that alerts the
user of an incomplete crimp.
If the tool is manually retracted before completion of
a crimp, the red LED and audible beep will be active
for 2 seconds.
If the tool is unable to reach the required crimp
force, the red LED, the work light, and an audible
beep will pulse until after the trigger is released.
