ASTRO V 112, Operating Instructions Manual

Programming with the KC 3

Operating Instructions V 112 - 

Version 07-2009A

Page 14 

Programming with the KC 3

Grundlagen der Bedienung

HINWEIS

:  

The section "Quick reference guide to program-

ming with the KC3" summarizes the operating steps that you 
need to follow to configure the plug-in card. The following 
section starts with basic instructions on how to operate the 
KC3. It then explains how to set all the parameters required for 
configuration.

HINWEIS

:  

Since it is not possible to set all the parameters 

of the V 112 using the KC3 programming unit, you should 
preferably program the card using the HE programming soft-
ware.

If you wish to program the V 112 plug-in card using the KC3 pro-
gramming unit, you must first connect the serial port of the KC3 to 
the serial port socket of the base unit being used (see left).
Once you have plugged in the KC3 programming unit, the start 
menu is displayed. The display shows the type of the base unit and 
the software version number (see left). Please quote this version 
number if you need to consult Customer Services.

If you wish to display the start menu again after entering program-
ming steps, you will need to disconnect the KC3 from the base unit 
first, then wait until the display goes blank, and then plug the con-
nector back in. 

Pressing the 



 or 



 cursor button takes you first into the menu for 

setting the base unit parameters. In this menu, use the 



 or 



 cur-

sor button to move to the line containing the parameter you wish to 
set. Press the 



 or 



 cursor button to change specific settings for 

the base unit parameters.

Pressing the 

Menu / Read

 button takes you to the menu for setting 

the card-specific parameters. The following parameters can be ad-
justed here in the respective lines:



Line 1: card type 



Line 3 / 4: output parameters