4 Programming with the KC 3
4 Programming with the KC 3
8
The RF output parameters are defined either by ente-
ring the video carrier frequency directly using the key-
pad (row 3), or by changing the output channel value
(line 4) step-by-step with the
←
or
→
cursor keys.
Please note:
As both channel pairs are converted jointly by one
modulator, the output frequencies of one channel pair
must not be adjusted independently of each other. The
frequency specified in channel A of a group is always
decisive; channel B is automatically assigned an offset
corresponding to the channel configuration.
Accordingly, the output frequency should always be
adjusted via the channel selection in row 4. This ensu-
res that the video carrier automatically receives a fre-
quency which corresponds to the channel
configuration.
With the cursor in the third row, click on the “Menu /
Read” button to open the
Audio mode selection menu.
Use the
←
or
→
cursor keys to change the audio mode.
You can choose from Mono, Stereo or 2-channel
sound. Press the “Menu / Read” button again to go to
Activation and deactivation of the output signal:
Use the
←
or
→
cursor keys to activate or deactivate
the output signal.
4.2
Moving between menus
•
Use the
↑
and
↓
arrow keys to change between
rows.
•
Press the MENU button to change between sub-
menus in a row.
4.3 Entering
parameters
•
Enter values directly via the keypad, or
•
Adjust the pre-defined parameters (e.g. Sat level)
in steps using the
←
or
→
cursor keys.
Important:
•
The numerical values must be entered in full.
4.4 Saving
•
Once all entries are complete the parameters need
to be saved so that they are adopted (i.e. set) by the
card and are protected against data loss in the event
of a power failure.
•
Save the parameters separately for each channel
group.
Press the STORE button to save the set parameters.
4.5
Programming the card-specific parameters
Once you have reached the required slot / channel
group by pressing the
←
or
→
cursor key in line 1 and
then selected line 3 or 4 with the
↑
or
↓
cursor key you
will come to the menu for
Defining the RF output parameters.
☞
☞