40
If the equipment does not work, please
contact the Technical Ser vice Depar tment and
advise them of the problem, indicating:
1
Serial number (S-No)
2
Appliance model. (Model)
You will find this information on the rating
plate on the lower par t of the oven when the
door is opened.
The item that you have bought meets the
European directives on electrical material
safety (73/23/CEE) and electromagnetic com-
patibility (89/336/CEE).
AENOR certifies the aptitude of this appliance
for the function and guarantees the truthful-
ness of all data shown in the energy card.
Technical Information
providing a minimum depth of 580 mm.
(See figures 1 and 2 describing oven fitting
on the page 68).
• To fit multifunction ovens in their locations,
the back par t of the unit corresponding to
the shaded area of figure 3, must not have
any projections (reinforcements, pipes,
sockets, etc). (See the page 68).
• The adhesive used for the plastic covering
of kitchen furniture must be able to
withstand temperatures up to 85ºC.
The installer must check that:
• The voltage and cycles of the mains supply
correspond to that indicated on the rating
plate.
• The electrical installation can stand the
maximum power indicated on the rating
plate.
• The connection diagram is shown in the
following figure.
• The electrical connection has adequate
ear thing in accordance with regulations in
force.
• The connection must be carried out with an
omnipolar switch, of an adequate size for
the current drawn. There must be a
minimum aper ture between contacts of 3
mm to enable disconnection in the case of
emergency, cleaning or bulb exchange.
Under no circumstances must the ear th
wire pass through this switch.
After connecting the electricity, check that all
the electrical par ts of the oven are working.
Electrical Connection.
Legal Requirements
Installation
This information is intended for the installer,
as the person responsible for assembly and
electrical connection. If you install the oven
yourself, the manufacturer will not be held
responsible for any possible damage.
• To unpack the oven, pull the tab located on
the lower par t of the box and to move it,
hold by the lateral handles and never by the
oven door handle.
• A niche is required in the kitchen unit as per
the dimensions shown on the figure,
Before Installation. Comments
