6
4. INSTALLATION
4.1
Safety instructions
•
All electrical installations shall be done in accordance with the local and national electrical codes. Do not remove the
casing. Inverter contains no user serviceable parts. Refer servicing to qualified service personnel. all wiring and electrical
installation should be conducted by a qualified service personnel .
•
Carefully remove the unit from its packaging and inspect for external damage. If you find any imperfections, please contact
your local dealer.
•
Be sure that the inverters connect to the ground in order to protect property and personal safety.
•
The inverter must only be operated with PV generator. Do not connect any other source of energy to it.
•
Both AC and DC voltage sources are terminated inside the PV Inverter. Please disconnect these circuits before servicing.
•
This unit is designed to feed power to the public power grid (utility) only. Do not connect this unit to an AC source or
generator. Connecting Inverter to external devices could result in serious damage to your equipment.
•
When a photovoltaic panel is exposed to light, it generates a DC voltage. When connected to this equipment, a photovoltaic
panel will charge the DC link capacitors.
•
Energy stored in this equipment’s DC link capacitors presents a risk of electric shock. Even after the unit is disconnected
from the grid and photovoltaic panels, high voltages may still exist inside the PV-Inverter. Do not remove the casing until at
least 5 minutes after disconnecting all power sources.
•
Although designed to meet all safety requirements, some parts and surfaces of Inverter are still hot during operation.
To reduce the risk of injury, do not touch the heat sink at the back of the PV-Inverter or nearby surfaces while Inverter is
operating.
•
According to VDE-AR-N 4105,password is given for protection. For CEI 0-21, no password needed.
4.2
Safety instructions
•
The installation method and mounting location must be suitable for the weight and dimensions of the inverter. Select a
wall or solid vertical surface that can support the PV-Inverter.
•
Mount on a solid surface, the mounting location must be accessible at all times.
