Chint Solar (Zhejiang) Co., Ltd. | Add:1335 Bin´an Road, Binjiang District, Hangzhou | P.C: 310053
Tel: 0086-571-5603 1888 | Fax: 086-571-5603 2316 | Website: http://energy.chint.com/
2.2.6 Do not touch the terminal box and the end of output cables (connectors) with bare hands.
2.2.7 Do not unplug the connector under load.
2.2.8 Do not work alone.
2.2.9 Wear a safety belt if working far above the ground.
2.2.10 Do not wear metallic jewelry, which can cause electric shock, while installing or
troubleshooting the PV system.
2.2.11 Follow the safety regulations for any and all other system components, including wires,
connectors, charging regulators, batteries, inverters, etc.
2.2.12 Do not expose wires to direct sunlight. Use UV-resistant cable.
2.2.13 Do not damage the surrounding PV modules or mounting structure when replacing a PV
module.
2.2.14 Do not change any PV module components (diode, junction box, plug connectors, etc.).
2.2.15 The maximum reverse current is 20.25A for module with Isc
≤
9.61A and 27A for module
with Isc
＞
9.61A. Application of the blocking diode and fuse in the combiner box are
recommended for reverse current protection when more than two strings are connected in
parallel.
2.2.16 A certain gap is maintained between the PV module and the mounting surface to prevent
the mounting surface touching the junction box.
2.2.17 Standing on the solar PV module is forbidden and also prohibit installation tools or other
objects hitting surface of the solar PV module.
2.2.18 The solar modules are recommended to be installed over a fireproof and insulating roof
covering when installed on a roof.
2.2.19 PV cable connection cannot be too tight, it is recommended that the connector and the
backsheet have a certain gap.
2.2.20 In sandy regions, in order to avoid getting sand into the connector, we suggest to short
circuit module connectors before installation. If grains of sand get into the connectors it,
may cause internal live parts wear and tear and affect electrical safety.
3 Mechanical Installation
3.1 Installation Conditions
3.1.1 Extreme environment temperature
：
-40
℃
to +85
℃
3.1.2 Operating temperature
：
-40
℃
to +85
℃
3.1.3 Mechanical load on panels (e.g., snow/wind): The max tested snow/wind load is
5400Pa/2400Pa, and the design load is 3600Pa/1600Pa with a safety factor 1.5 under
standard mounting system. Please refer to the detailed mounting instructions as Chapter
3.2.
3.1.4 Tilt Angle selection: The installation should be facing north in the southern hemisphere
