PXIe-3352 User Manual
Publication No. 981049 Rev. B
Getting Started 3-2
Astronics Test Systems
When inserting the module into the chassis, it should be gently rocked back and
forth to seat the connectors into the backplane receptacles.
Initial Power On
1. Drivers must be installed prior to hardware installation (see
2. Turn off the chassis power before installing the PXIe-3352.
3. Once the module is properly installed in the chassis, connect the GPS antenna
to the GPS ANT connector. Make sure that there is open view to the sky or if
indoors, no metal obstruction is above the antenna.
4. Turn on the chassis power.
The FAIL LED will illuminate for ~0.5s and then turn off if the module passes
the internal power on self test (POST).
If the PXIe-3352 fails POST, the FAIL LED will continue to be illuminated.
Should this happen, turn the chassis power off, re-install or make certain the
PXIe-3352 is properly installed in the chassis, and turn the chassis power back
on.
5. Turn on or re-start the computer connected to the chassis.
6. If this is the first time the PXIe-3352 is turned on, wait 5 minutes or until the
yellow Lock LED is turned on.