Chapter 2
–
Hardware Information
10
Co
mp
act
Fan
less
E
mb
ed
ded
AI@
Ed
ge
Bo
x
PC
BO
XE
R-
8254
AI
2.3 List of Jumpers
The board has a number of jumpers that allow you to configure your system to suit
your application.
The table below shows the function of each of the board's jumpers
Label
Function
CN3
AT/ATX Selection (Front Panel Connector Pins 7-8)
CN13
Mini Card mSATA/PCIe Selection
2.3.1
Setting Jumpers
You can configure your system to match the needs of your application by setting
jumpers. A jumper is the simplest kind of electric switch. It consists of two metal pins
and a small metal clip (often protected by a plastic cover) that slides over the pins to
connect them. To “close” a
jumper you connect the pins with the clip.
To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.
1 2
3
Open Closed Closed 2-3
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any questions about the best hardware configuration for your application,
contact your local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
Summary of Contents for Aaeon BOXER-8254AI
Page 17: ...Compact Fanless Embedded AI Edge Box PC BOXER 8254AI Chapter 2 Chapter 2 Hardware Information ...
Page 19: ...Chapter 2 Hardware Information 7 Compact Fanless Embedded AI Edge Box PC BOXER 8254AI ...
Page 21: ...Chapter 2 Hardware Information 9 Compact Fanless Embedded AI Edge Box PC BOXER 8254AI ...
Page 39: ...Compact Fanless Embedded AI Edge Box PC BOXER 8254AI Chapter 3 Chapter 3 OS Flash Guide ...
