DS300f G2 Series User Manual
113
v
IewInG
I
ScSI P
ort
I
nformatIon
To view information about a port:
1. Click the
Device
tab.
2. Click the
iSCSI Management
icon.
3. Click the
Port
tab.
4.
Click the port you want, then click the
View
button.
Port information includes:
• Controller ID
– ID of the RAID controller where the port is located
•
Status
– Enabled or disabled*
• Jumbo Frames
– Enabled or disabled*
• Link Status
– Up or down, active or inactive
• MAC Address
– MAC address of the target port
• Max Supported Speed
– Maximum speed supported (1 Gb/s)
• Current Speed
– Current or actual speed of the target port
• Relative Portals
– The portals corresponding to this target port
Items marked with an asterisk (*) are adjustable under "Making iSCSI Port Settings"
m
akInG
I
ScSI P
ort
S
ettInGS
To make iSCSI port settings:
1. Click the
Device
tab.
2. Click the
iSCSI Management
icon.
3. Click the
Port
tab.
4.
Click the port you want, then click the
Settings
button.
5. Make settings changes as required:
• Jumbo Frames
– Check to enable jumbo frame support on this port. Uncheck to disable.
6. Click the
Submit
button.
v
IewInG
a
l
ISt
of
I
ScSI t
runkS
A trunk is the aggregation of two or more iSCSI ports to increase bandwidth.
To view a list of trunks:
1. Click the
Device
tab.
2. Click the
iSCSI Management
icon.
3. Click the
Trunk
tab.
Trunk information includes:
• Trunk ID
– ID number of the trunk
• Controller ID
– ID of the RAID controller, 1 or 2
• Master Port
– ID of the master port
• Slave Ports
– IDs of the slave ports
• Failed Ports
– IDs of any ports that are not working
•
State
– Optimal, Sub-Optimal, or Failed
Failed ports result in sub-optimal and failed trunks.
a
DDInG
I
ScSI t
runkS
Ports must be
enabled
to add them to a trunk. ASUS DS300f G2 supports a maximum of eight trunks.
You cannot use an iSCSI port that has portals configured to it. See "
Viewing a List of iSCSI Portals" and "Deleting
To add an iSCSI trunk:
1. Click the
Device
tab.
2. Click the
iSCSI Management
icon.
3. Click the
Trunk
tab.
4. Click the
Create Trun
k button.
5. Make your choices as required:
• Controller ID
– ID of the RAID controller, 1 or 2
• Master Port number
– ID of the master port
• Slave Port number
– IDs the slave ports
Summary of Contents for DS300 G2 Series
