Chapter 2: Hardware Setup
2-8
Memory configurations
You may install 2 GB, 4 GB, 8 GB and 16 GB unbuffered and ECC and non‑ECC DDR4
DIMMs into the DIMM sockets.
You may install varying memory sizes in Channel A and Channel B. The system maps the
total size of the lower‑sized channel for the dual‑channel configuration. Any excess memory
from the higher-sized channel is then mapped for single-channel operation.
•
The default memory operation frequency is dependent on its Serial Presence Detect
(SPD), which is the standard way of accessing information from a memory module.
Under the default state, some memory modules for overclocking may operate at a
lower frequency than the vendor‑marked value.
•
For system stability, use a more efficient memory cooling system to support a full
memory load (8 DIMMs) or overclocking condition.
•
Always install the DIMMS with the same CAS Latency. For an optimum compatibility,
we recommend that you install memory modules of the same version or data code
(D/C) from the same vendor. Check with the vendor to get the correct memory
modules.
•
Visit the ASUS website for the latest QVL.
Summary of Contents for E500 G5 SFF
