Asus H110I, User Manual

1-2

Chapter 1: Product introduction

CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN) 

Connect the fan cables to the fan connectors on the motherboard, ensuring that the 

black wire of each cable matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside 

the system may damage the motherboard components. These are not jumpers! Do not 

place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan 

of maximum 1A (12 W) fan power.

ATX power connectors (24-pin EATXPWR, 4-pin ATX12V) 

Correctly orient the ATX power supply plugs into these connectors and push down 

firmly until the connectors completely fit.

• 

For a fully configured system, we recommend that you use a power supply unit 

(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides 

a minimum power of 350 W. 

• 

If you are uncertain about the minimum power supply requirement for your system, 

refer to the Recommended Power Supply Wattage Calculator at http://support.

asus.com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for 

details.

Intel

®

 LGA1151 CPU socket

Install Intel

®

 LGA1151 CPU into this surface mount LGA1151 socket, which is 

designed for 6th Generation Intel

®

 Core™ i7 / i5 / i3, Pentium

®

, and Celeron

®

processors.

For more details, refer to 

Central Processing Unit (CPU)

.

DDR4 DIMM slots

Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these 

DIMM sockets.

For more details, refer to 

System memory

.

Speaker connector (4-pin SPEAKER)

The 4-pin connector is for the chassis-mounted system warning speaker. The 

speaker allows you to hear system beeps and warnings.

System panel connector (10-1 pin PANEL)

This connector supports several chassis-mounted 

functions.

PIN 1

PWR BTN

GND

PWR

PWR_LED-

(NC)

HWRST#

Ground

HDD_LED-

F_PANEL

+PWR_LED-

+HDD_LED- RESET