Chapter 5
iPBX30 User Manual
34
5.2.3.1 WAN PPPoE Unnumbered Configuration Parameters
The table below describes the configuration parameters available
for PPPoE Unnumbered connection mode.
Table 5.3. WAN PPPoE Unnumbered Configuration Parameters
Setting
Description
Link
Select a port to configure. Available options are WAN1,
WAN2 or DMZ.
Connection
Mode
Select PPPoE Unnumbered from the connection mode
drop-down list. Traditionally, each network interface must
have a unique IP address. However, an unnumbered
interface does not have to have a unique IP address. This
means that when this option is selected, the WAN and the
LAN use the same IP address. Network resources are
therefore conserved because fewer network IP addresses
are used and routing table is smaller.
Enable NAPT
Check or uncheck this box to enable NAPT for this
connection.
User Name and
Password
Enter the username and password you use to log into your
ISP. (Note: this is different from the information you used to
log into Web UI Management.)
Service Name
Enter the service name provided by your ISP. Service name is
optional but may be required by some ISPs.
AC Name
Enter the access concentrator name provided by your ISP.
Access concentrator name is optional but may be required
by some ISPs.
IP Address
Enter a static IP address here for the PPPoE unnumbered
connection. This IP address must be provided by your
service provider.
Unnumbered
Network
Address
Enter the network address provided by your ISP.
Primary /
Secondary DNS
Server
IP address of the primary or secondary DNS are optional
as PPPoE will automatically detect the DNS IP addresses
configured at your ISP. However, if there are other DNS
servers you would rather use, enter the IP addresses here.
Summary of Contents for iPBX30
Page 1: ...iPBX30 User Manual E2883 December 2006 ...
Page 151: ......
