iPBX30 User Manual
Chapter 7
55
Enable
or
Disable
radio button.
7. (Optional) If authentication is enabled, you must also select
authentication mode and the desired authentication key.
8. Click
Apply
to save the settings.
7.3
Static Route
Figure 7.2. Static Route Configuration Page
7.3.1 Static Route Configuration Parameters
The following table defines the available configuration parameters
for static routing configuration.
Table 7.2. Static Route Configuration Parameters
Field
Description
Destination
Address
Specifies the IP address of the destination computer or
an entire destination network. It can also be specified as
all zeros to indicate that this route should be used for all
destinations for which no other route is defined (this is the
route that creates the default gateway). Note that destination
IP must be a network ID. The default route uses a destination
IP of 0.0.0.0. Refer to Appendix 11 for an explanation of
network ID.
Summary of Contents for iPBX30
Page 1: ...iPBX30 User Manual E2883 December 2006 ...
Page 151: ......
