73
Appendix
Appendix
Additional Information
The use of this equipment may be subject to
local rules and regulations. The following rules
and regulations may be relevant in some or all
areas where your handset will be in operation.
european Notice
Products with the mark comply with the Radio
& Telecommunication Terminal Equipment
Directive (1999/5/EEC), the Electromagnetic
Compatibility Directive (89/336/EEC) and
the Low Voltage Directive (73/23/EEC) - as
amended by Directive 93/68/ECC - issued by
the Commission of the European Community.
Compliance with these directives implies
conformity to the following European Standards:
• 1999/5/EEC Radio & Telecommunication
Terminal Equipment Directive (R&TTE)
EN 301 511
• Specific Absorption Rate (SAR)
Standard: EN 50360, EN 50361
• 73/23/EEC Low Voltage Directive (LVD)
Standard: EN 60950:2000
• 89/336/EEC Electromagnetic
Compatibility (EMC-Directive) Standard:
EN 301489-1/7
• The manufacturer cannot be held
responsible for modifications made by
the user and the consequences thereof,
which may alter the conformity of the
product with the mark.
Certification Information
(SAR)
this mobile phone meets eU requirements
for exposure to radio waves.
Your mobile phone is a radio transmitter
and receiver, designed and manufactured to
meet limits of exposure to radio frequency
(RF) based on international guidelines and
recommendations of The Council of the
European Union. These limits are part of
comprehensive guidelines that establish
permitted levels of RF energy for the general
population. Independent scientific organizations
developed these guidelines through periodic
and thorough evaluation of scientific studies.
The guidelines provide a substantial safety
margin to ensure the safety of all persons,
regardless of age and health.
The exposure standard for mobile devices
is measured by a unit known as the Specific
Absorption Rate, or SAR. According to
international guidelines, the SAR limit is
2.0 watts/kilogram (W/kg)*. SAR testing is
conducted using standard operating positions
with the device transmitting at its highest
certified power level in all tested frequency
