A S U S K 8 N 4 - E
A S U S K 8 N 4 - E
A S U S K 8 N 4 - E
A S U S K 8 N 4 - E
A S U S K 8 N 4 - E
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
2 - 1 7
2.3.5
2.3.5
2.3.5
2.3.5
2.3.5
Primary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/Slave
Primary and Secondary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE
devices. There is a separate sub-menu for each IDE device. Select a device
item then press <Enter> to display the IDE device information.
Before attempting to configure a hard disk drive, make sure you have
the correct configuration information supplied by the drive
manufacturer. Incorrect settings may cause the system to fail to
recognize the installed hard disk.
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Sector and Transfer Mode). These values are not
user-configurable. These items show N/A if no IDE device is installed in the
system.
Primary IDE Master/Slave [Auto];
Primary IDE Master/Slave [Auto];
Primary IDE Master/Slave [Auto];
Primary IDE Master/Slave [Auto];
Primary IDE Master/Slave [Auto];
Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]
Secondary IDE Master/Slave [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the BIOS automatically fills in the correct values for
the remaining fields on this sub-menu. If the hard disk was already
formatted on a previous system, the setup BIOS may detect incorrect
parameters. Select [Manual] to manually enter the IDE hard disk drive
parameters. If no drive is installed select [None].
Configuration options: [None] [Auto] [Manual]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
Access Mode [Auto]
The default [Auto] allows automatic detection of an IDE hard disk drive.
Select [CHS] for this item if you set the IDE Primary Master/Slave to
[Manual]. Configuration options: [CHS] [LBA] [Large] [Auto]
F1:Help
↑↓
: Select Item
-/+: Change Value
F5: Setup Defaults
ESC: Exit
→←
: Select Menu
Enter: Select Sub-menu
F10: Save and Exit
Phoenix-Award BIOS CMOS Setup Utility
Main
Select Menu
Item Specific Help
Press [Enter] to
select
Primary IDE Master
Primary IDE Master
[
Auto
]
Access Mode
[Auto]
Capacity
xxxxx MB
Cylinder
xxxxx
Head
xx
Sector
xx
PIO Mode
[Auto]
UDMA Mode
[Auto]
Transfer Mode
xxxxxxx
Summary of Contents for K8N4-E
Page 1: ...Motherboard K8N4 E ...
Page 12: ...x i i x i i x i i x i i x i i ...
