2-36
Chapter 2: BIOS setup
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default
Not Installed
. After you set
a password, this item shows
Installed
.
To set a Supervisor Password:
1. Select the
Change Supervisor Password
item and press
<Enter>
.
2. From the password box, type a password composed of at least six letters
and/or numbers, then press
<Enter>
.
3. Confirm the password when prompted.
The message
Password Installed
appears after you successfully set your
password.
To change the supervisor password, follow the same steps in setting a supervisor
password.
To clear the supervisor password, select the
Change Supervisor Password
then
press
<Enter>
. The message
Password Uninstalled
appears.
2.6.3
Security
The
Security
menu items allow you to change the system security settings. Select
an item then press
<Enter>
to display the configuration options.
Select Screen
Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Security Settings
Supervisor Password
:Not Installed
User Password
:Not Installed
Change Supervisor Password
Change User Password
<Enter> to change
password.
<Enter> again to
disabled password.
BIOS SETUP UTILITY
Boot
If you forget your BIOS password, you can clear it by erasing the CMOS Real
Time Clock (RTC) RAM. See section
1.9 Jumpers
for information on how to
erase the RTC RAM.
After you have set a supervisor password, the other items appear to allow you to
change other security settings.
Summary of Contents for M3A78-CM - Motherboard - Micro ATX
Page 1: ...Motherboard M3A78 CM ...
