ASUS MCB-10G-2S
2-5
2.1.3
iSCSI Boot Configuration
Comprehensive Configuration Management v7.8.21
Copyright (C) 2000-2013 Broadcom Corporation
All rights reserved.
General Parameters
Initiator Parameters
1st Target Parameters
2nd Target Parameters
Secondary Device Parameters
iSCSI Boot Main Menu
Configure General Boot Parameters
[Enter]:Enter Next Menu; [
↑|↓
]:Next Entry; [ESC]:Quit Menu
Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7
General Parameters
TCP/IP Parameters via DHCP [Enabled]
This option applies to IPv4.
[Enabled] The iSCSI boot host software acquires the IP address from the DHCP
server.
[Disabled] The iSCSI boot host software acquires the static IP address.
iSCSI Parameters via DHCP [Enabled]
[Enabled] The iSCSI boot host software acquires its iSCSI target parameters from
the DHCP server.
[Disabled] The iSCSI boot host software acquires its iSCSI target parameters via the
static IP address, which is entered through the iSCSI Initiator Parameters
Configuration screen.
CHAP Authentication [Disabled]
[Enabled] Allows the iSCSI boot host software to use CHAP authentication when
connecting to the iSCSI target. Enter the CHAP ID and CHAP Secret in the
Initiator Parameters configuration screen.
[Disabled] Does not allow the iSCSI boot host software to use CHAP authentication
when connecting to the iSCSI target.
Boot to iSCSI Target [Enabled]
[Enabled] The iSCSI boot host software immediately attempts to boot from the iSCSI
target after successfully connecting to it.
[Disabled] The iSCSI boot host software does not attempt to boot from the iSCSI
target after successfully connecting to it. The control will then return to the
system BIOS so that the next boot device may be used.
