ASUS N3050I-CM-A
1-5
DMIC connector (4-pin DMIC)
The DMIC connector is for connecting the digital microphone
module used in All-in-One chassis.
PIN 1
+3.3V DMIC_DATA DMIC_CLK GND
DMIC
Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or
switch cable to this header. The chassis intrusion sensor or
switch sends a high-level signal to this header when a chassis
component is removed or replaced. The signal is then generated
as a chassis intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are
shorted with a jumper cap. Remove the jumper caps only when
you intend to use the chassis intrusion detection feature.
PIN 1
+5VSB_MB
Chassis Signal GND
CHASSIS
Front panel audio connector (10-1 pin
AAFP)
This connector is for a chassis-mounted
front panel audio I/O module that supports
either HD Audio or legacy AC`97 audio
standard. Connect one end of the front
panel audio I/O module cable to this
connector.
AAFP
PIN 1
AGND NC SENSE1_RETUR
SENSE2_RETUR
PORT1 L PORT1 R PORT2 R
SENSE_SEND
PORT2 L
HD-audio-compliant
pin definition
PIN 1
AGND NC NC
NC
MIC2
MICPWR
Line out_R
NC
Line out_L
Legacy AC’97
compliant definition
•
We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
•
If you want to connect a high-definition front panel audio module to
this connector, set the Front Panel Type item in the BIOS setup to [HD
Audio]. If you want to connect an AC’97 front panel audio module to this
connector, set the item to [AC97]. By default, this connector is set to [HD
Audio].
Internal stereo speaker header (4-pin SPK_OUT)
The internal mono speaker header allows connection to an
internal, low-power speaker for basic system sound capability.
The subsystem is capable of driving a speaker load of 4 Ohms at
3 Watts (rms).
+5V GND GND Speaker Out
SPEAKER
PIN 1
