ASUS PCI-SIU2 User’s Manual
65
Adding the driver to an existing OS/2 system
For computer systems using other SCSI host adapters or an IDE device to
provide the system boot routines, these instructions will guide you through
PCI-SIU2 host adapter driver installation. The OS/2 driver will be found on
the PCI-SIU2 DRIVER DISK 1. It is important that the SCSI bus hardware
and OS/2 are installed correctly before proceeding further.
1
Once an OS/2 session is established, insert the PCI-SIU2 DRIVER
DISK 1 into your floppy drive.
2
By using your installed mouse, or by using the appropriate key strokes,
select DEVICE DRIVER INSTALL from the SYSTEM SETUP
group.
3
Select CHANGE source directory to read as the root directory.
4
Select OS2 and select SET.
5
Select DESTINATION DIRECTORY.
6
Select CHANGE destination directory to any existing OS/2 directory
or accept the default.
7
Select SET.
8
From the DEVICE DRIVER INSTALLATION GROUP select IN-
STALL.
9
Select PCI SCSI Device Driver for OS/2 select “OK”.
10
Select EXIT to install the OS/2 device driver. Exit and reboot the sys-
tem to activate the device driver.
Device driver command line options
The ASUS device drivers support command line switches to optimize driver
performance. Device drivers normally require no further information to work
effectively. However, in certain situations some driver optimization may be
advantageous to system performance. From inside the CONFIG.SYS file use
the following format to edit the file.
The standard format for command line switches is:
BASEDEV = INIA100.ADD [Driver Config Option]
10. OS/2 Driver Installation
