Chapter 2: Hardware setup
-1
4. Place the ODD side bracket to the
ODD, matching the two connectors
of the bracket with the holes on the
side of the ODD.
ODD.side.bracket
Bracket.
connectors
5. Secure the ODD side bracket to
the Serial SATA drive bracket with
a screw.
6. Connect a 80-pin IDE cable black
connector and a 4-pin ATX power
connector to the IDE connector and
power connector at the rear of the
optical disk drive.
Summary of Contents for RS100-X5 - 0 MB RAM
