2-11
ASUS RS520-E8-RS8 V2, RS520-E8-RS12-EV2
2.3.4
Removing a DIMM
1.
Simultaneously press the retaining
clips outward to unlock the DIMM.
2.
Remove the DIMM from the socket.
2.3.3
Installing a DIMM
3.
Hold the DIMM by both of its ends
then insert the DIMM vertically into
the socket. Apply force to both ends
of the DIMM simultaneously until the
retaining clips snaps back into place.
Ensure that the DIMM is sitting firmly
on the DIMM slot.
Ensure to unplug the power supply before adding or removing DIMMs or other system
components. Failure to do so may cause severe damage to both the motherboard and the
components.
1.
Unlock a DIMM socket by pressing
the retaining clips outward.
2.
Align a DIMM on the socket such that
the notch on the DIMM matches the
DIMM slot key on the socket.
A DIMM is keyed with a notch so that it fits in only one direction. DO NOT force a DIMM into
a socket in the wrong direction to avoid damaging the DIMM.
Support the DIMM lightly with your fingers when pressing the retaining clips. The DIMM
might get damaged when it flips out with extra force.
Always insert the DIMM into the socket VERTICALLY to prevent DIMM notch damage.
Locked Retaining Clip
Unlocked retaining clip
DIMM notch
DIMM slot key
Summary of Contents for RS520-E8-RS12-EV2
