40
LED projector E-Manual
NOTE:
The following screenshots are for reference only and may be
updated without prior notice. Screenshots may also vary depending
on the LED projector model.
Using your LED projector for the
first time
Refer to the following steps when using your LED projector for the
first time.
NOTE:
Ensure that your LED projector is connected to the
power adapter before turning it on for the first time. We strongly
recommend that you use a grounded wall socket while using your
LED projector on power adapter mode.
1. Set up your LED projector then press the power button.
2. Move the joystick left or right on your LED projector (or press
the
Left
or
Right
button on your remote control) to browse
through the available language options.
3. After you have chosen your preferred language, press the
center of the joystick (or press the
Menu/OK
button on your
remote control) to set this language for use on your LED
projector.
4. You may now start using your LED projector to display files
from your input device. The
NO SIGNAL
screen may appear if
no input device is connected or cannot be detected by the LED
projector.
Summary of Contents for S2 Series
