Chapter 2: Hardware Setup
2-34
2.9.2
Redundant power supply module (TS700-E8-RS8 V2 only)
To install the redundant power supply module:
1.
Locate the redundant power supply
you want to remove on the rear
panel of your chassis. Move the
handle on it upward.
2.
Press the latch to the left and pull
the power supply module out of the
system chassis.
3.
Insert the replacement power supply
module into the chassis. You will
hear a sound when the power supply
module is secured in place.
Summary of Contents for TS700-E8-PS4 V2
