5-38
Chapter 5: RAID configuration
5.4.2
Change Volume Type
When you are finished to create a RAID set, you can view or change related items
in the
Volume Properties
field.
According to the following steps to change the type in
Volume Properties
:
1. Click the SATA array items you want to change in
Volumes
field.
2
From the
Volume Properties
field, select
Type:RAID 1 Change type
.
We recommend a lower stripe size for server systems, and a higher stripe size
for multimedia computer systems used mainly for audio and video editing.
3. You can change the
Name
,
Select the new volume type
, and
Select
additional disks to include in the new volume
if needed.
4. Then select the
Data stripe size
for the RAID array (for RAID 0, 10 and 5
only), and then click
OK
. The available stripe size values range from 4 KB to
128 KB. The following are typical values:
RAID 0: 128KB
RAID 10: 64KB
RAID 5: 64KB
Summary of Contents for Z9NH-D12
