End Wheels
The tools required for wheel removal and installation
are listed in table 11-2. Use manufacturer recommend-
ed tools whenever possible.
Table 11-2
Removal
Figure 11-7 11-011
1.
Raise and support the machine on ASV jackstands
in the front and rear as shown.
Figure 11-8 11-012
2.
Clean the threads with a plastic or wire bristle
brush, then loosen the turnbuckle as shown to
lower the drive table and create slack in the track.
Figure 11-9 11-013
3.
Remove the bolts securing the wheel to the hub.
Figure 11-10 11-014
4.
Slide the track outward as you pull on the wheel to
remove the wheel.
Installation
1.
To install the end wheels, reverse the removal pro-
cedure.
Torque the end wheel mounting bolts
upon installation to 95 +/- 10 Lb. Ft.
11-3
Rubber Track Loader
11. Undercarriage Disassembly and Assembly
Required Tools
Socket/impact wrench
Heavy duty hydraulic jack
Combination wrench
ASV approved jack stands (2)
