20.
If necessary, use a needle dispenser to fill any
places in the bearing that are not full of grease to
ensure adequate lubrication. (fig. 11-44)
21.
Remove the allen plug in the center portion of the
hub. (fig. 11-45)
22.
Add 1 oz. of ASV 10W-30 Heavy Duty Engine Oil
to the hub as shown, then reinstall the plug and
tighten. (fig. 11-46)
23.
The hub assembly is now ready to be reinstalled.
To install it onto the machine, reverse steps 1-3 on
page 11-7 of this procedure. Make sure to read the
note below step 3 prior to reinstalling.
24.
Repeat this procedure throughout the undercar-
riage as necessary to repair worn or damaged
components and restore proper function.
11-11
Rubber Track Loader
11. Undercarriage Disassembly and Assembly
11-44
11-45
11-46
