10
Pre-Start Checklist
Before operating the machine, perform a
pre-operation safety check. Inspect the
machine for any items that may affect
safe operation.
Check to make sure:
1. Engine compartment, chassis and
coolers are clean and free of debris.
2. Windows and lights are clean and
unobstructed.
3. Tracks are in good condition and are
properly tensioned.
4. Fluids are filled to proper levels.
5. Accessory belts are in good condition
and properly tensioned.
6. Hyd. Hoses and fittings are in good
condition. (no visible signs of wear)
7. Battery cables are in good condition
and properly fastened.
8. Joysticks and hyd. auxiliary switches
are in their neutral positions.
9. Power quick-attach is in locked posi-
tion. (if equipped)
Starting Procedure
Before starting the engine, perform the
pre-start checklist then proceed with the
following procedure:
1. Enter machine with lift arms all the
way down. Maintain three points of
contact with the machine (photo A).
2. Fasten seat belt, and lower lap bar
into position.
3. Starting with the throttle in the SLOW
position, push the throttle 1/3 the way
open.
4. Turn the ignition key to the left for 6
seconds to “pre-heat” the engine.
While pre-heating, the glow plug
operation light will illuminate.
5. Turn the ignition key to the right to
start the engine.
6. Run the engine at low idle for 3 to 5
minutes to warm up the engine.
7. Set throttle to desired rpm.
Note:
The parking brake is automatically
engaged when the engine is turned off,
the operator is not in the seat or the lap
bar is raised.
M
MA
AC
CH
HIIN
NE
E O
OP
PE
ER
RA
AT
TIIO
ON
N
Entering or exiting the vehicle under raised
lift arms could cause serious injury or
death. Never allow anyone to be under-
neath raised, unsecured lift arms (photo B).
WARNING
A
B
