Rubber Track Loader
6. Chassis Disassembly and Assembly
6-4
Figure 6-11
6-005
2. Insert the fuel sending unit float mechanism into
the fuel tank opening. Be careful not to damage
the float when pushing it through the opening.
Note: Make sure that the wire on the sending unit is not
bent and the fuel pickup line does not interfere with the
movement of the float.
Fuel
Sending
Unit
Figure 6-12
6-004
3. Connect the hoses and wires to the fuel sending
unit, then install the screws that fasten the unit
to the tank.
Note: Be careful not to cross the wires or hoses. If the
fuel sending unit wires are crossed, the fuel gauge will not
work. If the hoses are crossed, the engine will not run.
4. Install the seat. Refer to Chapter 6. Seat Instal-
lation procedure.
Fuel Tank Removal and
Installation
The tools required for fuel tank removal and installa-
tion are listed in Table 6-3. Use manufacturer-
recommended tools whenever possible.
Table 6-3
Required Tools
Screwdriver
Combination Wrench
Socket Wrench
Fuel Tank Removal
1. Remove the seat. Refer to Chapter 6. Seat Re-
moval procedure.
Figure 6-13
6-014
2. View of fuel tank with seat removed.
3. Pump all fuel from the fuel tank.
NOTICE
Collect and contain liquids in a suitable container. Dispose
of all liquids according to local regulations and mandates.
https://www.tractormanualpdf.info/
Summary of Contents for RC30
