76 / 96
METER INSTRUCTION
“
3
”
Normal way to operate PROGRAM (P2~P7)
“
A.
“
ENTER MANUAL PROGRAM (P2~P7)
”
d.
START
/STOP
button:
If you have selected other program (P1 or P8 ~ P16), pressing
START
/STOP
button to pause the current
program
e.
UP
or
DOWN
button:
Press
UP
or
DOWN
button to select
PROGRAM (P2 ~ P7)
f.
ENTER
button:
Press
ENTER
button to confirm and enter
PROGRAM (P2 ~ P7)
“
B. SET THE DESIRED TIME or DESIRED DISTANCE
To avoid the user to select TIME and DISTANCE in the same program to confuse the user couldn’t
distinguish which one (TIME or DISTANCE) as the first priority. User could only select TIME or
DISTANCE in the same program, one at the time
If you would like to select TIME value, not
DISTANCE value:
UP
or
DOWN
button:
c. After pressing the
ENTER
button to enter into
PROGRAM (P2 ~ P7)
, the
TIME
function
mode will appear with the display flashing “0:00”
d. Use
UP
or
DOWN
buttons to set the desired
TIME (1:00 TO 99:00; 1 MINUTE INCREMENT)
NOTE for TIME:
Count Up: If a target time was not selected,
TIME
will count up from 0:00 to maximum 99:59
minutes
Count Down: If you have set the target time, the
console will count down from that selected
target time down to 0:00
If you would like to select DISTANCE value, not
TIME value:
ENTER
button and then
UP
or
DOWN
button:
a. After pressing the
ENTER
button to enter into
PROGRAM (P2 ~ P7)
, the
TIME
function
mode will appear with the display flashing “0:00”.
b. Press the
ENTER
button again, the
DISTANCE
function mode will then appear with the display
flashing “0.0”
c. Use
UP
or
DOWN
buttons to set the desired
DISTANCE (1 TO 999KM/MILE; 1 KM/MILE
INCREMENT)
NOTE for DISTANCE:
Count Up: If a target distance was not selected,
this would measure the total distance from 0:00
to 999 km/mile
Count Down: If you have set the target distance,
the console will count down from the selected
target time down to 0
Summary of Contents for RA6_0
Page 1: ......
Page 6: ...6 96 EXPLOSIONSZEICHNUNG ...
Page 47: ...47 96 PULSMESSTABELLE ...
Page 54: ...54 96 EXPLODED DIAGRAM ...
