Rubber Track Loader
12. Undercarriage Disassembly and Assembly
12-11
Sprocket Bearing Plate Installation
Figure 12-45
12-028
1.
If the bearing flanges were split to inspect the
bearing or install a new bearing, place the
flanges together. Attach the flanges to the bear-
ing plate with the four flange bolts.
Figure 12-46
12-039
2.
Slide the bearing plate unto the shaft.
Figure 12-47
12-040
3.
Install and tighten the two bolts that fasten the
bearing plate to the drive table.
Figure 12-48
12-041
4.
Slide the lock collar all the way unto the shaft
until it stops. Rotate the lock collar in the direc-
tion opposite to which it was loosened. Using a
punch in the punch hole, tighten the collar.
Tighten the allen bolt.
Sprocket Removal and
Installation
The tools required for sprocket removal and installa-
tion are listed in Table 12-6. Use manufacturer-
recommended tools whenever possible.
Table 12-6
Required Tools
Socket Wrench
Impact Driver
Sprocket Puller
Sprocket Removal
Figure 12-49
12-030
https://tractormanualz.com/
Summary of Contents for RC30 2022
