7
DMP801
English
DMP801 SOFTWARE
Connection
For a connection to be established between the
Asystems remote software and the DMP801, first both
need to be connected to the same local area network�
After installing the Asystems Control Software, you
simply need to push the “SCAN” button located on the
bottom left-hand side of the software� This will locate and
identify any appropriate Asystems products�
After the scan is complete, your Asystems products will
be found to the left-hand side of the software� You can
add any of these to your setup using the main work area
of the software� The software’s connection to the device
is already complete and you can double-click the device
icon to operate the product’s various functions�
Firmware
It is possible to update the DMP801 firmware through the
network. This is done by first connecting to the device
through the network� You must then launch the “Flash
Programmer” found in the pull-down menu at the top of
the software�
The firmware update must first be downloaded from
www.asystems-sys.com
. To start the firmware update,
the DMP801 must be able to receive the update� Pin 1
of the DIP switch on the back must be set to the upper
position to do so�
Select the firmware update file in the PC software by
clicking “Select File”. Once the new firmware file is
selected, you just need to check your unit’s IP address�
Provided your unit is already setup within the Flash
Programmer menu, click “Reprogram” to begin� Do not
turn off your computer or DMP801 during the firmware
update process�
DSP
The DSP page will give you an overall idea of input
and output mixes (including levels and naming) as well
as offer a manner to view and edit the current signal
processors assigned to input and output channels�
Name:
Edit the name for each of the individual input
channels�
On/Off:
Use this button to switch the corresponding
input channel on and off�
Processing:
These buttons allow you to inject any of the
DMP801’s internal signal processors right into the input
chain� Processing will be accomplished in order from left
to right� For more information on the available programs,
check the Signal Processor section of this manual
Mix Matrix:
The DMP801 essentially only has a single
output, therefore Matrix may be a bit of misnomer,
however this is used for routing your input signals
appropriately�
Reset Button:
Pushing these buttons will reset the DSP
parameters for the input or output, including name, on/off
status, and selected signal processors� There is a reset
button available for each the input and output�
Monitoring:
The DMP801 software offers extensive
monitoring for DSP performance� The percentage of the
processor used will be visible at the bottom of the page�
